The machine rolls up a profile from the tube’s inside. The profile’s exterior is not marked by the tools, which means that the sealing capability is much improved compared to conventional end forming.

The bulb’s diameter and position can be easily programmed to achieve the desired profile.

Contact us for for more information.

We produce magazines according to customers’ requirements and our own standard.

ML20-10-32 can feed tubes Ø10 - 32 mm, length 200-2,000 mm. Connect to air (6 bar) and 1x230V, 50/60 Hz power. Isolated relay I/O’s for robot connection. Emergency circuit shall be controlled from the connected machine.

M2L200-10-16 feed tubes from two different levels. This gives you greater flexibility in your production. Connect as above.

Contact us for for more information.

Specially developed for bending of tubes with only one bend, as a pump connection for an AC pump. This machine has very high productivity compared to conventional machines. maskiner.

It has two electric servos and is fully programmable for different tubes.

Contact us for for more information.

Fully automatic cell with bending machine that loads tubes from a coil or magazine. It has a tube cut-, end form- and drilling station. It can run 4 different articles at the same time and drop them in different bins. It has 9 electric servos, hydraulic tube clamping, automatic lubrication, etc. The machine can bend everything from copper to titanium in a radius 1.5 x tube diameter. It has the Lantz PC based control system.

Contact us for for more information.

The machine has 2 independent work stations for crimping of long hose assemblies for air conditioning. Each side also has some assembly fixtures.

It comes with the Lantz PC controlled system with Machine Vision.

Contact us for for more information.

During the years, we have delivered a wide range of tools and machines for various purposes.

Contact us for for more information.